Rohde & Schwarz RTP044 - Page 2185

Remote control commands
R&S
®
RTP
2185User Manual 1337.9952.02 ─ 12
EYE<m>:HORizontal:UINTerval:BITRate........................................................................2187
EYE<m>:HORizontal:UINTerval:RANGe.........................................................................2187
EYE<m>:HORizontal:UINTerval:POSition....................................................................... 2187
EYE<m>[:STATe] <State>
Activates or deactivates the eye diagram.
Suffix:
<m>
.
1..4
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
EYE<m>:SOURce
<MainSource>
Selects the waveform from which the eye diagram is generated (data source). For ana-
log channels, peak detect, envelope, and average waveforms are not supported.
Suffix:
<m>
.
1..4
Parameters:
<MainSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
Usage: Asynchronous command
EYE<m>:TREFerence[:SOURce] <TimeRefSource>
Selects the waveform that is used to obtain the timing information required to slice the
data source waveform.
Suffix:
<m>
.
1..4
Parameters:
<TimeRefSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4
Usage: Asynchronous command
EYE<m>:TREFerence:SLOPe <TimeRefSlope>
Sets the edge on the timing reference waveform to define the timestamps for slicing
the data waveform. A timestamp is set each time, when the selected slope of the tim-
ing waveform crosses the selected reference level.
Suffix:
<m>
.
1..4
Protocols