Rohde & Schwarz RTP044 - Page 2231

Remote control commands
R&S
®
RTP
2231User Manual 1337.9952.02 ─ 12
WGENerator<m>:ARBGen:MULTichannel:OPEN
Loads the arbitrary waveform.
Suffix:
<m>
.
1..2
Example: See WGENerator<m>:ARBGen:MULTichannel:IMPort
on page 2230.
Usage: Event
Asynchronous command
WGENerator<m>:ARBGen:NAME
<FilePath>
Sets the file path and the file for an arbitrary waveform, if WGENerator<m>:ARBGen[:
SOURce] on page 2232 is set to ARBitrary.
If not path is given, the default path
C:\Users\Public\Public Documents\Rohde-Schwarz\RTx\RefWaveforms
is used.
This command is only relevant for files with one waveform defined. For multichannel
arbitrary waveform files, see WGENerator<m>:ARBGen:MULTichannel:OPEN.
Suffix:
<m>
.
1..2
Parameters:
<FilePath>
WGENerator<m>:ARBGen:OPEN
Loads the arbitrary waveform, that is selected with the WGENerator<m>:ARBGen:
NAME command.
This command is only relevant for files with one waveform defined. For multichannel
arbitrary waveform files, see WGENerator<m>:ARBGen:MULTichannel:OPEN.
Suffix:
<m>
.
1..2
Usage: Event
Asynchronous command
WGENerator<m>:ARBGen:RUNMode <RunMode>
Sets the duration for which the signal of the arbitrary generator will be output after the
trigger event.
Suffix:
<m>
.
1..2
Waveform generator (option R&S RTP-B6)