Triggers
R&S
®
RTP
257User Manual 1337.9952.02 ─ 12
Clock source
Selects the input channel of the clock signal.
Remote command:
TRIGger<m>:SETHold:CSOurce[:VALue] on page 1272
Clock edge
Together with the clock level, the clock edge sets the point in time when the state of the
data signal is checked:
"Positive"
Rising edge, a positive voltage change.
"Negative"
Falling edge, a negative voltage change.
"Both"
Both the rising and the falling edge.
Remote command:
TRIGger<m>:SPATtern:CSOurce:EDGE on page 1279
Clock level
Sets the voltage level for the clock signal.
Remote command:
TRIGger<m>:SPATtern:CSOurce:LEVel on page 1280
Data level
Sets the voltage level for the data signal.
If the signal value is higher than the data level, the state is 1. Below the level, the sig-
nal state is 0.
Remote command:
TRIGger<m>:LEVel<n>[:VALue] on page 1255
Couple levels (Trigger level and hysteresis coupling)
Sets the trigger levels and hysteresis values for all channels to the values of the cur-
rently selected trigger source. The function affects only the levels defined for the
selected condition. The hysteresis of the external trigger input is an independent value,
and it is not affected by level coupling.
High-speed serial pattern trigger (Option R&S
RTP-K140/K141)
To Next Page
Loading...
