Rohde & Schwarz RTP044 - Page 576

Protocol analysis
R&S
®
RTP
576User Manual 1337.9952.02 ─ 12
SEARch:TRIGger:CAN:ACKerror on page 1643
SEARch:TRIGger:CAN:FDATa:SCERror on page 1644
13.5.5.2 Search results
To get search results, "Enable" the search. You can minimize, shift or close the search
dialog.
The search results are listed in the search result table and marked in the waveform by
blue lines.
For an introduction to search results, see:
●
Chapter 11.1.2, "Search results", on page 449
●
Chapter 11.4.2, "Display zoom settings", on page 468
Remote commands:
●
SEARch:RESult:CAN:FCOunt? on page 1646
●
SEARch:RESult:CAN:FRAMe<m>:STATus? on page 1650
●
SEARch:RESult:CAN:FRAMe<m>:FERCause? on page 1649
●
SEARch:RESult:CAN:FRAMe<m>:ACKState? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:ACKValue? on page 1646
●
SEARch:RESult:CAN:FRAMe<m>:BSEPosition? on page 1647
●
SEARch:RESult:CAN:FRAMe<m>:BYTE<n>:STATe? on page 1647
●
SEARch:RESult:CAN:FRAMe<m>:BYTE<n>:VALue? on page 1647
●
SEARch:RESult:CAN:FRAMe<m>:CSSTate? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:CSValue? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:DATA? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:DLCState? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:DLCValue? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:IDSTate? on page 1648
●
SEARch:RESult:CAN:FRAMe<m>:IDTYpe? on page 1649
●
SEARch:RESult:CAN:FRAMe<m>:IDValue? on page 1649
●
SEARch:RESult:CAN:FDATa:FRAMe<m>:STANdard? on page 1650
●
SEARch:RESult:CAN:FRAMe<m>:STARt? on page 1650
●
SEARch:RESult:CAN:FRAMe<m>:STOP? on page 1651
●
SEARch:RESult:CAN:FRAMe<m>:SYMBol? on page 1651
●
SEARch:RESult:CAN:FRAMe<m>:TYPE? on page 1651
13.5.5.3 Searching CAN FD data
The "Identifier + Data" search supports the search for data bytes of specific value at a
specific location in the data field of a frame. The "Data Pattern" field provides 8 data
CAN and CAN FD (option R&S
RTP-K3/K9)