Rohde & Schwarz RTP044 - Page 620

Protocol analysis
R&S
®
RTP
620User Manual 1337.9952.02 ─ 12
"Label + Data"
Sets the trigger on a defined word format. You can define the label,
the data and the SDI / SSM bits separately, see "Label + Data"
on page 620.
"Error Condition"
Identifies various errors in the word, see "Error Conditions"
on page 621.
Remote command:
TRIGger<m>:ARINc:TYPE on page 1714
Label + Data
Sets the trigger on a defined word format. You can define the label, the data and the
SDI / SSM bits separately.
Label setup: Condition, Label Min, Label Max ← Label + Data
The label setup consists of the condition and one or two label patterns.
"Condition"
Defines the operator to set a specific label ("Equal" or "Not equal") or
a label range.
ARINC 429 (option R&S RTP-K7)