Protocol analysis
R&S
®
RTP
628User Manual 1337.9952.02 ─ 12
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Protocol
Defines the protocol type of the selected serial bus.
Remote command:
BUS<m>:TYPE on page 1548
Decode
Enables the decoding of the selected bus. The signal icon of the bus appears on the
signal bar.
Remote command:
BUS<m>[:STATe] on page 1548
Ethernet Variant
Defines the Ethernet protocol variant and transmission speed.
"10BASE-T"
Selects the Ethernet protocol variant 10BASE-T (standard data rate
10 Mbit/s).
"100BASE-TX"
Selects the Ethernet protocol variant 100BASE-TX, which provides
100 Mbit/s use data rate. Due to 4b/5b encoding, the raw data rate on
the line is 125 Mbit/s. This value is used by R&S RTP-K8 as the bit
rate default for 100BASE-TX.
Ethernet 10BASE-T and 100BASE-TX (option R&S RTP-K8)
To Next Page
Loading...
