Protocol analysis
R&S
®
RTP
695User Manual 1337.9952.02 ─ 12
Additional search parameters are provided under "Detailed Search Parameter Setup".
For details, see also "Type" on page 685.
"Sequence Start"
Searches for SSC.
Additional search parameter: "Slave Addr." on page 696
"Sequence Stop"
Searches for bus park at the end of a command sequence.
Additional search parameter: "Slave Addr." on page 696
"Register 0 Write"
Searches for Register 0 Write command sequences. Additional
search parameters:
●
Slave address, see "Slave Addr." on page 696.
●
Data pattern, see "Data" on page 697
"Register Write"
Searches for Register Write command sequences. Additional search
parameters:
●
Slave address, see "Slave Addr." on page 696
●
Register address, see "Address" on page 697
●
Data pattern, see "Data" on page 697
"Register Read"
Searches for Register Read command sequences.
This search uses the same additional parameters as the Register
Write search.
"Extended Register Write"
Searches for Extended Register Write command sequences. Addi-
tional search parameters:
●
Slave address, see "Slave Addr." on page 696
●
Byte count, see "Byte count" on page 696
●
Register address, see "Address" on page 697
●
Data pattern, see "Data" on page 697 and "Index" on page 697
"Extended Register Read"
Searches for Extended Register Read command sequences.
This search uses the same additional parameters as the Extended
Register Write search.
"Extended Register Write Long"
Searches for Extended Register Write Long command sequences.
This search uses the same additional parameters as the Extended
Register Write search.
"Extended Register Read Long"
Searches for Extended Register Read Long command sequences.
This search uses the same additional parameters as the Extended
Register Write search.
RFFE (option R&S RTP-K40)
To Next Page
Loading...
