Rohde & Schwarz RTP044 - Page 778

Protocol analysis
R&S
®
RTP
778User Manual 1337.9952.02 ─ 12
Autoset
Starts software algorithms for determining the signal threshold levels and bitrate.
Remote command:
BUS<m>:FAUToset on page 1549
Sync symbol
Selects the sync symbol, a control symbol used for low-level control functions. You can
select one of the comma control symbols (K28.1, K28.5, K28.7) used for synchroniza-
tion or you can enter a pattern.
Remote command:
BUS<m>:EBTB:SYNC on page 1978
Pattern
Selects a pattern that serves as a sync symbol.
Remote command:
BUS<m>:EBTB:FCSY on page 1977
Pattern 2
Enables a second pattern that serves as a sync symbol and sets its value.
Remote command:
BUS<m>:EBTB:SCSY on page 1978
BUS<m>:EBTB:USCS on page 1978
13.16.2.3 Display settings
Access: [Protocol] > "Display" tab.
For common display settings, see Chapter 13.1.3, "Display", on page 514.
8b/10b (option R&S
RTP-K52)