Protocol analysis
R&S
®
RTP
811User Manual 1337.9952.02 ─ 12
13.18.3.1 USB 2.0 trigger settings
Access: [Protocol] > "Shortcuts" tab > "Setup trigger"
In this section, all trigger settings are described. Their availability on the instrument
depends on the selected USB 2.0 protocol type and trigger type. The user interface of
the instrument displays only appropriate settings and guides you through the trigger
setup.
For a list of supported trigger conditions, refer to data sheet.
Trigger on protocol types USB high speed and USB HSIC is currently not supported.
Figure 13-29: USB trigger event settings dialog
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Trigger type USB
Selects the trigger type for USB 2.0 analysis. The available trigger types depend on the
USB 2.0 protocol type that is selected in the configuration setup, see "Protocol type"
on page 807.
Remote command:
TRIGger<m>:USB:TYPE on page 2008
USB (option R&S
RTP-K60)
To Next Page
Loading...
