Rohde & Schwarz RTP044 - Page 963

Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
963User Manual 1337.9952.02 ─ 12
Carrier period
Sets the period of the carrier signal.
Remote command:
WGENerator<m>:MODulation:CARRier:PERiod on page 2225
15.1.3.2 AM modulation
For amplitude modulation (AM), the amplitude of the carrier signal is varied according
to the modulation signal.
Modulation signal
Selects the type of the modulation signal for the AM modulation types.
Remote command:
WGENerator<m>:MODulation:AM[:FUNCtion] on page 2225
Modulation freq
Sets the frequency of the modulation waveform.
Remote command:
WGENerator<m>:MODulation:AM:FREQuency on page 2224
Modulation depth
Sets the modulation depth, the percentage of the amplitude range that is used for the
modulation.
Setup of the waveform generator