Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
971User Manual 1337.9952.02 ─ 12
Sample rate
Sets the sample rate for the arbitrary waveform.
Remote command:
WGENerator<m>:ARBGen:SRATe on page 2232
Samples
Displays the number of samples in the loaded waveform.
Remote command:
WGENerator<m>:ARBGen:SAMPles? on page 2232
Run single
Generates a single period of the arbitrary waveform if "Run mode" is set to "Single
period".
Remote command:
WGENerator<m>:ARBGen:RUNSingle on page 2233
15.1.5.2 Saved waveform
For a saved waveform, the following settings are available:
Load arbitrary waveform
Opens a file selection dialog box and loads the selected file. Supported are .bin
and .csv extension files.
Remote command:
WGENerator<m>:ARBGen:NAME on page 2231
WGENerator<m>:ARBGen:OPEN on page 2231
Setup of the waveform generator
To Next Page
Loading...
