Rohde & Schwarz RTP164 - Page 2139

Remote control commands
R&S
®
RTP
2139User Manual 1337.9952.02 ─ 12
Parameters:
<Ordering> ANY | STRONG | RELAX
*RST: ANY
TRIGger<m>:PCIE:TLP:REID <TLPRequesterID>
Sets the requester ID to be triggered on for the transaction layer type trigger.
Parameters:
<TLPRequesterID> 16-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:SNOO
<Snoop>
Sets the snoop state to be triggered on for the transaction layer type trigger.
Parameters:
<Snoop> ANY | YES | NO
*RST: ANY
TRIGger<m>:PCIE:TLP:SNUM <TLPSeqNo>
Sets the sequence numbe to be triggered on for the transaction layer type trigger.
Parameters:
<TLPSeqNo> 12-bit pattern, see Chapter 22.4.6, "Bit pattern parameter",
on page 1148. The string parameter accepts the bit value X
(don't care).
TRIGger<m>:PCIE:TLP:TCHN <TrafficClass>
Sets the traffic class to be triggered on for the transaction layer type trigger.
Parameters:
<TrafficClass> ANY | ZERO | ONE | TWO | THREE | FOUR | FIVE | SIX |
SEVEN
*RST: ANY
TRIGger<m>:PCIE:TLP:TYPE <Type>
Sets the transaction type to be triggered on for the transaction layer type trigger.
Parameters:
<Type> ANY | MEM | IO | CFG | MSG | CPL | FETCH | SWAP | CAS
*RST: ANY
Protocols