Rohde & Schwarz RTP164 - Page 2272

Remote control commands
R&S
®
RTP
2272User Manual 1337.9952.02 ─ 12
ADVJitter<m>:RESult:STEPresponse <State>
Enables a step response diagram for the advanced jitter measurements..
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:COMPonents<n>:HISTogram <State>
Enables a histogram for the selected measurement component.
Suffix:
<m>
.
1..2
<n> 1..29
See Table 22-20
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:COMPonents<n>:SPECtrum <State>
Enables a spectrum diagram for the selected measurement component.
Suffix:
<m>
.
1..2
<n> 1..29
See Table 22-20
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:RESult:COMPonents<n>:TRACk <State>
Enables a track for the advanced jitter measurements.
Suffix:
<m>
.
1..2
<n> 1..29
See Table 22-20
Parameters:
<State> ON | OFF
*RST: OFF
Jitter analysis and clock data recovery