Rohde & Schwarz Scope Rider RTH - Serial Pattern Trigger (R&SRTH-K19)

Remote Control Commands
R&S
®
Scope Rider RTH
328User Manual 1326.1578.02 ─ 12
Parameters:
<HoldTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
TRIGger:DATatoclock:STIMe <SetupTime>
Sets the minimum time before the clock edge while the data signal must stay steady.
The setup time can be negative. In this case, the hold time has to be positive. The
setup time is defined by TRIGger:DATatoclock:HTIMe.
Parameters:
<SetupTime> Range: -124E-9 to 124E-9
Increment: 1E-9
*RST: 1E-9
Default unit: s
15.3.5.12
Serial Pattern Trigger (R&S RTH-K19)
TRIGger:SPATtern:DSOurce[:VALue]............................................................................... 328
TRIGger:SPATtern:CSOurce[:VALue]............................................................................... 328
TRIGger:SPATtern:CSOurce:EDGE................................................................................. 328
TRIGger:SPATtern:CSOurce:FIRStedge...........................................................................329
TRIGger:SPATtern:ORDer.............................................................................................. 329
TRIGger:SPATtern:PATTern............................................................................................ 329
TRIGger:SPATtern:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:SPATtern:CSOurce[:VALue] <Source>
Sets the input channel of the clock signal.
Parameters:
<Source> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
TRIGger:SPATtern:CSOurce:EDGE <Slope>
Sets the edge at which the data value is sampled.
Parameters:
<Slope> POSitive | NEGative | EITHer
Waveform Setup