Rohde & Schwarz Scope Rider RTH - Page 480

Remote Control Commands
R&S
®
Scope Rider RTH
480User Manual 1326.1578.02 ─ 12
TRIGger:SENT:IRFLength <FrameLengthError>
Triggers on frame length errors in transmission sequences, if BUS:SENT:PPULse is
set to PPFL. A frame length error occurs, when the total length of the transmission
sequence (including pause pulse) does not match the frame length set with BUS:
SENT:PPFLength.
Parameters:
<FrameLengthError> ON | OFF
*RST: ON
TRIGger:SENT:PPERioderror
<PulsePeriodError>
Triggers on an error in the calibration/sync pulse in transmission sequences of the fast
channel.
Parameters:
<PulsePeriodError> ON | OFF
*RST: ON
TRIGger:SENT:PULSeerror <SyncPulseError>
Trigggers on a synchronization/calibration pulse error in transmission sequences of the
fast channel.
Parameters:
<SyncPulseError> ON | OFF
*RST: ON
TRIGger:SENT:SCRCerror <SlowCRCError>
Triggers on a detected CRC error in serial messages of the slow channel. The CRC
length is 4 bits for short serial messages, and 6 bit of enhanced serial messages.
Parameters:
<SlowCRCError> ON | OFF
*RST: ON
15.11.7.3 SENT Decode Results
The frame suffix <m> selects the frame index for which the result is queried.
The byte suffix <n> selects the byte index for which the result is queried.
BUS:SENT:FCOunt?...................................................................................................... 481
BUS:SENT:FRAMe<m>:CSValue?...................................................................................481
BUS:SENT:FRAMe<m>:DATA?....................................................................................... 481
BUS:SENT:FRAMe<m>:DSTatus?................................................................................... 482
BUS:SENT:FRAMe<m>:IDTYpe?.....................................................................................482
BUS:SENT:FRAMe<m>:IDValue?.................................................................................... 482
Protocol Analysis