Preparing for use
R&S
®
Scope Rider RTH
25Getting Started 1326.1561.02 ─ 10
3.5 Considerations for test setup
Observe safety instructions, see "Performing measurements" on page 8.
Cable selection and electromagnetic interference (EMI)
Electromagnetic interference (EMI) can affect the measurement results.
To suppress electromagnetic radiation during operation:
●
Use high-quality shielded cables, for example, double-shielded RF and LAN
cables.
●
Always terminate open cable ends.
●
Ensure that connected external devices comply with EMC regulations.
Measuring accessories
Use only probes and measuring accessories that comply with IEC 61010-031.
Signal input and output levels
Information on signal levels is provided in the specifications document. Keep the
signal levels within the specified ranges to avoid damage to the product and con-
nected devices.
Considerations for test setup
To Next Page
Loading...
