Instrument tour
R&S
®
Scope Rider RTH
33Getting Started 1326.1561.02 ─ 10
1 = Measurement results, which depend on the mode and the selected measurement
2 = Time scale (horizontal scale, in s/division)
3 = Trigger type, trigger source and trigger mode
4 = Capture status
5 = Battery status and AC connectivity for battery charging; date and time
6 = Trigger level marker, has the color of the trigger source
7 = Trigger position marker, has the color of the trigger source
8 = Channel markers indicate the ground levels. Channel C3 has the focus
9 = Vertical settings for each active channel: vertical scale (vertical sensitivity, in V/division),
bandwidth limit (no indicator = full bandwidth, BW= limited frequency), coupling (AC or DC)
10 = Logic channels (MSO R&S RTH-B1)
11 = Menu button
You can adjust the vertical position of each waveform, the trigger level, and the
trigger position by dragging the corresponding marker on the display. Alterna-
tively, tap a marker to set the focus, and use the wheel to adjust the position.
Display overview
To Next Page
Loading...
