Operating the instrument
R&S
®
Scope Rider RTH
43Getting Started 1326.1561.02 ─ 10
Key Press shortly Press and hold
[SHIFT] opens a dialog to save and load
instrument settings.
Press and hold for 2 seconds
to disable or enable the
touchscreen.
If a dialog or menu is open, [BACK] closes it. If the menu is closed, the key
toggles the focus between the focused element in the diagram and the
Menu button.
Open or close the "Mode", "File" or "Setup" dialog, respectively.
Saves measurement documentation:
Only screenshot if "one touch" is off. ZIP file
with selected data if "one touch" is on.
Opens or closes the "Screen-
shot" dialog to configure the
screenshot and the "one
touch" output.
All R&S RTH:
Only
R&S RTH1004:
The effect depends on the channel state:
If the channel is off, the key switches on the
channel and sets the focus. The key lights
up.
If the channel is on but not in focus, the key
sets the focus. The key lights up.
Open or close the "Vertical"
dialog for the corresponding
channel to configure the
channel settings.
Only
R&S RTH1002:
[DMM] starts or stops the meter measure-
ments (same as [MODE] = "Meter").
[DMM REL] enables or disables relative
meter measurements.
Opens or closes the "Meter"
dialog to configure the mea-
surements.
[TIME] and [POS] adjust the horizontal time scale and position of the trigger
point.
[RANGE] and [POS] set the vertical scale (vertical sensitivity) and the verti-
cal position of the focused waveform (analog or channel, math or reference
waveform).
Accessing the functionality
To Next Page
Loading...
