EasyManua.ls Logo

Rohde & Schwarz Scope Rider RTH1004 - Page 6

Rohde & Schwarz Scope Rider RTH1004
53 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety and regulatory information
R&S
®
Scope Rider RTH
6Getting Started 1326.1561.02 ─ 10
Using the product requires specialists or specially trained personnel. These users
also need sound knowledge of at least one of the languages in which the user
interfaces and the product documentation are available.
Reconfigure or adjust the product only as described in the product documentation
or the specifications document. Any other modifications can affect safety and are
not permitted.
Never open the casing of the product. Only service personnel authorized by
Rohde & Schwarz are allowed to repair the product. If any part of the product is
damaged or broken, stop using the product. Contact Rohde & Schwarz customer
support at https://www.rohde-schwarz.com/support.
Choosing the operating site
The product is designed for usage according to its protection class noted in the
specifications document. Interpret the protection class as follows:
IP51: Protection against dust and vertically falling drops of water or condensa-
tion.
IP54: Protection against splashing water from any direction.
The protection class listed in the specifications document only applies to battery
operation. If you operate the product with an external power supply, you can use
it indoors only in pollution degree 2 environments where nonconductive contami-
nation can occur. To maintain the protection class, always cover the openings of
the product. Water that enters can electrically connect the casing to live parts.
Observe the ambient conditions such as altitude, operating temperature and cli-
matic loading; see the specifications document.
Setting up the product
You can carry the product with you, in your hands or in a carrying accessory
designed for the product to leave your hands free for work.
If you put the product down, place its rear side on a flat and level surface, e.g. a
table.
If you use the product in a vehicle, install it in the vehicle mount provided for this
purpose. Secure the product safely so that it cannot fall out and hurt passengers
when the vehicle is moving.
Safety instructions

Other manuals for Rohde & Schwarz Scope Rider RTH1004

Related product manuals