Rohde & Schwarz Scope Rider RTH1004 - Page 133

Spectrum Analysis
R&S
®
Scope Rider RTH
133User Manual 1326.1578.02 ─ 12
9
8
7
6
5
4
3
2
1
11 13 14 15
10
12
Figure 6-4: Harmonic results and display
(1) Order of harmonic..................................................................................................133
(2) Power level of fundamental frequency...................................................................133
(3+4) Power level of individual harmonics...................................................................134
(5+6) Limit line and check for individual harmonics.................................................... 134
(7) Power level scale...................................................................................................134
(8) Input channel......................................................................................................... 134
(9) Result type for numeric results.............................................................................. 134
(10) Operating status.................................................................................................. 135
(11) Error indicator.......................................................................................................135
(12) RMS.....................................................................................................................135
(13) Total harmonic distortion (THD)........................................................................... 135
(14) Selected harmonic............................................................................................... 136
(15) Numeric results for selected harmonic................................................................ 136
(1) Order of harmonic
Results are displayed for each of 64 possible harmonic frequencies. You can restrict
the number of harmonics to be analyzed (see "Display Harmonics, Max No Harmonics"
on page 140).
Remote command:
(determined by suffix <n> in remote command)
(2) Power level of fundamental frequency
The calculated power level at the fundamental frequency. The graphical level results
are indicated in relation to the power level of the fundamental frequency. Thus, this bar
is always at 100 % or 0 dB.
Remote command:
HARMonic:RESult<m>:HARMonics1:ABSMagnitude?
Harmonics Measurement (Option R&S
RTH-K34)