Rohde & Schwarz Scope Rider RTH1004 - Page 136

Spectrum Analysis
R&S
®
Scope Rider RTH
136User Manual 1326.1578.02 ─ 12



64
2i
2
i,RMS
1,RMS
F
U
U
1
THD
●
Relative to the total power of the signal (THD
R
):
2
F
F
R
THD1
THD
THD


Remote command:
HARMonic:RESult<m>:THD[:CURRent]? on page 378
HARMonic:RESult<m>:THD:MINimum? on page 378
HARMonic:RESult<m>:THD:MAXimum? on page 378
HARMonic:THDType on page 371
(14) Selected harmonic
Some results are provided for a single, selected harmonic. You select the harmonic by
tapping the number at the bottom of the bargraph. The selected harmonic is highligh-
ted.
Remote command:
(determined by suffix <n> in remote command)
(15) Numeric results for selected harmonic
The following numeric results are displayed for the (14) Selected harmonic:
●
Order of the harmonic
●
Magnitude (relative to (2) Power level of fundamental frequency and absolute
value)
●
Phase (percent or dB, depending on Scale setting)
●
Frequency
Remote command:
HARMonic:RESult<m>:HARMonics<n>:ABSMagnitude[:CURRent]?
on page 373
HARMonic:RESult<m>:HARMonics<n>:ABSMagnitude:MINimum? on page 373
HARMonic:RESult<m>:HARMonics<n>:ABSMagnitude:MAXimum? on page 373
HARMonic:RESult<m>:HARMonics<n>:RELMagnitude[:CURRent]?
on page 375
HARMonic:RESult<m>:HARMonics<n>:RELMagnitude:MINimum? on page 375
HARMonic:RESult<m>:HARMonics<n>:RELMagnitude:MAXimum? on page 375
HARMonic:RESult<m>:HARMonics<n>:PHASe? on page 375
HARMonic:RESult<m>:HARMonics<n>[:FREQuency]? on page 376
6.3.3 Performing a Harmonic Measurement
1. Select the "Harmonic" mode.
2. To adjust the instrument settings to the current input signal automatically, press
[AUTOSET].
Harmonics Measurement (Option R&S
RTH-K34)