Multimeter Measurements
R&S
®
Scope Rider RTH
147User Manual 1326.1578.02 ─ 12
4. To set the range mode to autoranging or manual range setup, press [AUTOSET].
5. If you are in manual range mode, adjust the measurement range: Press the
[RANGE] keys.
6. For current and temperature measurements, adjust the "Probe Setting" in the
"Meter" menu.
7. For continuity measurement, adjust the "Resistance Threshold".
8. If you want to get relative result values:
a) Activate "Relative" (no. 10).
b) To set a user-defined reference value, open the "Meter" menu.
c) Activate "Reference".
d) Enter the reference value in "Reference Manual".
9. To stop the meter measurement, press the [RUN STOP] key.
The status "Hold" is displayed on the upper left. Stopping the measurement does
not delete statistical values. The measurement continues when you press [RUN
STOP] again.
7.1.5 Settings
Access: "Meter" menu
Figure 7-3: Digital multimeter settings
Meter Type
Sets the measurement type for the multimeter.
Meter icon "Meter Type" Description
"V AC" AC voltage measurement
"V DC" DC voltage measurement
"V AC+DC" AC+DC voltage (RMS) measurement
Digital Multimeter (R&S RTH1002)
To Next Page
Loading...
