Rohde & Schwarz Scope Rider RTH1004 - Voltmeter (R&S RTH1004)

Multimeter Measurements
R&S
®
Scope Rider RTH
149User Manual 1326.1578.02 ─ 12
1 = Reference value
2 = Actual value relative to reference value
Remote command:
Chapter 15.7.3, "Relative Measurements", on page 386...
Reference/Reference Manual
"Reference" activates or deactivates the setting of a manual reference value.
If active, enter the reference value in "Reference Manual".
Restart Test
Restarts the measurement.
[RANGE] / [POS]
In meter mode, the vertical [RANGE] and [POS] keys adjust the DMM measurement
range and reset statistical values.
Remote command:
Chapter 15.7.2, "Measurement Configuration", on page 379
7.2 Voltmeter (R&S RTH1004)
The software-based voltmeter features AC, DC, AC+DC voltage measurements. Cur-
rent measurements are also possible if you use a shunt resistor or I/U converter.
The R&S RTH can run four voltmeter measurement in parallel, the maximum resolution
is 999 counts and 3 digits.
All remote commands for configuration and measuring are listed in Chapter 15.8, "Volt-
meter (R&S RTH1004)", on page 394.
7.2.1 Accessing the Meter Mode
1. Press the [MODE] key.
2. Select "Meter".
The multimeter interface is displayed.
Voltmeter (R&S
RTH1004)