Multimeter Measurements
R&S
®
Scope Rider RTH
150User Manual 1326.1578.02 ─ 12
7.2.2 Display and Control
The voltmeter display shows all 4 voltmeters at a glance, or only one voltmeter with
details and setup icons.
Figure 7-4: One-voltmeter-view
1 = Measurement state. "Manual": running measurement. "Hold": stopped measurement.
2 = Probe settings
3 = Minimum value and timestamp
4 = Average value
5 = Maximum value and timestamp
6 = Warning sign, shows up if the measured value is higher than 30 V
7 = Bargraph displaying the measured value
8 = Measurement source (input channel). Selected source is highlighted.
9 = Measurement ranges of active channels
10 = Measurement type (AC, DC or AC+DC). Selected type is highlighted.
11 = Restarts the measurement and resets all values
12 = Activates or deactivates relative measurement
13 = On/Off-Switch to turn selected meter on or off
14 = Displayed voltmeter, indicated by highlighted number
The buttons at the bottom of the display offer the following quick settings:
●
Input Signal
●
Measure Type
●
Restart Test
●
Relative
Voltmeter (R&S
RTH1004)
To Next Page
Loading...
