Data Logging
R&S
®
Scope Rider RTH
167User Manual 1326.1578.02 ─ 12
1. If data logging is running, press [RUN/STOP] to stop the logging. The logged data
is saved automatically to the slot.
2. Press the [FILE] key.
3. Tap "Logger Records".
4. Tap "Export As".
5. Select the "File Type", enter the "File Name", and change the folder if necessary.
If a USB flash drive is attached, the file is stored there. Otherwise, the file is stored
in the Export folder on the microSD card.
6. Tap "Save".
The data of the last used slot is saved.
Remote commands:
●
LOGGer:SLOT:EXPort:NAME on page 425
●
LOGGer:SLOT:EXPort:SAVE on page 425
8.6.1 Logger Records in MATLAB
To analyze logger records in MATLAB, save the logger data in a MAT file. When you
load tha file in MATLAB, you see the following structure:
The "logger" structure contains a substructure "measurement":
The "measurement" structure contains the values:
Export of Logger Records
To Next Page
Loading...
