Getting Started
R&S
®
Scope Rider RTH
20User Manual 1326.1578.02 ─ 12
Risk of electrical shock or fire
Voltages higher than 30 V RMS or 42 V peak or 60 V DC are regarded as hazardous
contact voltages. When working with hazardous contact voltages, use appropriate pro-
tective avoid electrical shock and injuries:
●
Use only insulated probes, cables, test leads and adapters.
●
Do not touch voltages higher than 30 V RMS or 42 V peak or 60 V DC.
See also: Chapter 2.1.2, "Input Isolation", on page 9.
2.3.3 Right View
1
= LAN
2 = USB type B for remote control
3 = Probe compensation
4 = USB type A for flash drive
5 = Logic probe connector
Risk of injury or instrument damage
Always close the lids of the communication ports and DC input when they are not in
use.
LAN connector
RJ-45 connector to connect the instrument to a Local Area Network (LAN). It supports
up to 100 Mbit/s.
USB type A connector
USB type A connector to connect a USB flash drive to store and reload instrument set-
tings and measurement data.
Instrument Tour
To Next Page
Loading...
