Rohde & Schwarz Scope Rider RTH1004 - Page 296

Network Connections
R&S
®
Scope Rider RTH
296User Manual 1326.1578.02 ─ 12
The list contains all countries where the wireless LAN option has been approved.
You also can find the list in the data sheet.
4. Select "Wireless Mode" = "Client" in the "Wireless LAN" menu.
5. Enable "Wireless State".
The "Choose Access Point" window opens.
6. Tap the "SSID" of the required router.
7. Enter the password of the required router in "Passphrase".
The connection status is shown in "Status"
Description of settings
Country
Select the country, where you use the wireless LAN. The list contains all countries
where the wireless LAN option has been approved.
Only available in option R&S RTH-K200.
Wireless State
Enables or disables wireless LAN access.
Wireless Mode
Selects the wireless LAN function of the instrument. It can serve as access point or as
client.
Remote command:
SYSTem:COMMunicate:WLAN:MODE on page 503
SSID
Shows the wireless LAN identifier of the instrument. You can change the identifier.
Wireless LAN Connection (Option R&S
RTH-K200/200US)