Remote Control Commands
R&S
®
Scope Rider RTH
316User Manual 1326.1578.02 ─ 12
PxxxxLyyHZ
HDTV standards using progressive scanning (P). xxxx indicates
the number of active lines, yy is the frame rate.
Triggering on HDTV standards requires option R&S RTH-K19.
IxxxxLxxHZ
HDTV standards using interlaced scanning (I). xxxx indicates the
number of active lines, yy is the field rate.
P1080L24HZSF
1080p/24sF is a HDTV standard using progressive segmented
frame scanning.
CUSTom
Used for signals of other video systems, for example, medical
displays, video monitors, and security cameras. Requires option
R&S RTH-K19.
*RST:
PAL
TRIGger:TV:POLarity
<Polarity>
Sets the polarity of the signal. Note that the sync pulse has the opposite polarity, for
example, a positive signal has a negative sync pulse.
Parameters:
<Polarity> POSitive | NEGative
*RST: POSitive
TRIGger:TV:MODE <Mode>
Selects the lines or fields on which the instrument triggers. Available modes depend on
the scanning system of the selected standard.
Parameters:
<Mode> ALL | ODD | EVEN | ALINe | LINE
ALL
All fields: Triggers on the first video line of the frame (progres-
sive scanning) or field (interlaced scanning), for example, to find
amplitude differences between the fields.
ODD | EVEN
Odd fields / even fields: Triggers on the first video line of the odd
or even field. These modes are available for interlaced scanning
(PAL, PAL-M, SECAM, NTSC, 1080i) and progressive segmen-
ted frame scanning (1080p/24sF). They can be used, for exam-
ple, to analyze the components of a video signal.
ALINe
All lines: Triggers on the line start of all video lines, for example,
to find maximum video levels.
LINE
Triggers on a specified line. Specify the line number using
TRIGger:TV:LINE.
Waveform Setup
To Next Page
Loading...
