Rohde & Schwarz Scope Rider RTH1004 - Page 319

Remote Control Commands
R&S
®
Scope Rider RTH
319User Manual 1326.1578.02 ─ 12
TRIGger:PATTern:WIDTh:DELTa..................................................................................... 320
TRIGger:PATTern:WIDTh:MINWidth.................................................................................321
TRIGger:PATTern:WIDTh:MAXWidth................................................................................321
TRIGger:PATTern:STATe[:CHANnel<m>] <State>
Sets the state of each input channel. The channel is specified by the channel suffix:
The logical combination of the channel states is defined by TRIGger:PATTern:
STATe:COMBination.
Suffix:
<m>
.
1..4: analog channel 1 to 4
8..15: digital channels D0 to D7
Parameters:
<State> ONE | ZERO | DONTcare
ONE
The signal value is above the defined threshold.
ZERO
The signal value is below the defined threshold.
DONTcare
The signal state does not matter.
*RST: DONTcare
TRIGger:PATTern:STATe:COMBination <ChCombination>
Sets the logical combination for all active channels. The required state of each channel
is defined by TRIGger:STATe:CHANnel<m>.
Parameters:
<ChCombination> AND | OR
*RST: AND
TRIGger:PATTern:WIDTh:RANGe <Condition>
Adds additional time limitation to the pattern defined by TRIGger:PATTern:STATe[:
CHANnel<m>] and TRIGger:PATTern:STATe:COMBination.
Parameters:
<Condition> ANY | TIMeout | LONGer | SHORter | EQUal | NEQual |
WITHin | OUTSide
ANY
Triggers on all runts fulfilling the level condition, without time lim-
itation.
Triggers if the signals match the pattern definition for a minimum
time, which is specified by TRIGger:PATTern:TIMeout[:
TIME].
Waveform Setup