Getting Started
R&S
®
Scope Rider RTH
33User Manual 1326.1578.02 ─ 12
Remote command:
OP[:MODE] on page 298
2.4.3 Displaying an Unknown Signal
The R&S RTH can display unknown, complex signals automatically. The [AUTOSET]
function analyzes the enabled channel signals, and adjusts the horizontal, vertical, and
trigger settings to display stable waveforms.
1. Press the [PRESET] key.
[PRESET] sets the instrument to a default factory state. The previous user-defined
configuration is removed and all channels except for channel 1 are disabled.
2. Press the [AUTOSET] key.
The waveform is displayed.
2.4.4 Getting Information and Help
In most dialogs, graphics explain the meaning of the selected setting. For further infor-
mation, you can open the help, which provides functional description of the settings
with links to the corresponding remote commands, and background information.
Note: When the help window is open, you can use only the [SHIFT] and [BACK] keys.
Other keys may not work as expected. Close the help window before you use the keys.
2.4.4.1 Displaying Help
●
"To open the help window" on page 33
●
"To show information on a setting" on page 34
●
"To close the help window" on page 35
To open the help window
► Tap the "Help" icon on the top of the menu.
Operating Basics
To Next Page
Loading...
