Remote Control Commands
R&S
®
Scope Rider RTH
336User Manual 1326.1578.02 ─ 12
<Source2> C1 | C2 | C3 | C4 | M1 | R | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
MEASurement<m>:TYPE <Type>
Selects the measurement type. For a detailed description, see Chapter 4.2.3, "Mea-
surement Types", on page 80.
Suffix:
<m>
.
1..4
Parameters:
<Type> PERiod | FREQuency | RTIMe | FTIMe | PPULse | NPULse |
PDCYcle | NDCYcle | DELay | PHASe | MEAN | RMS | CRESt |
STDDev | MINimum | MAXimum | PKPK | BASelevel |
TOPLevel | AMPLitude | OVRShoot | PREShoot | AC | DC |
ACDC | PPCount | NPCount | RECount | FECount | PWRP |
PWRS | PWRQ | PWRFactor
*RST: MINimum
RTIMe Rise time
PREShoot Preshoot
FTIMe Fall time
PPCount Positive pulse count
PPULse Positive pulse width
NPCount Negative pulse count
NPULse Negative pulse width
RECount Rising edge count
PDCYcle Positive duty cycle
FECount Falling edge count
NDCYcle Negative duty cycle
PWRP Active power
STDDev Standard deviation
PWRS Apparent power
PKPK Peak to peak
PWRQ Reactive power
OVRShoot Overshoot
PWRFactor Power factor
MEASurement<m>:AOFF
Disables all active measurements.
Suffix:
<m>
.
1..4
The suffix is irrelevant.
Usage: Event
MEASurement<m>:DELay:SLOPe <Slope>
Sets the slope for the delay measurement type.
Waveform Analysis
To Next Page
Loading...
