Rohde & Schwarz Scope Rider RTH1004 - Page 356

Remote Control Commands
R&S
®
Scope Rider RTH
356User Manual 1326.1578.02 ─ 12
15.6.2.1 Configuring the Measurement
SPECtrum:MODE?.........................................................................................................356
SPECtrum:FREQuency:AVERage:COUNt........................................................................ 356
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO.................................................... 356
SPECtrum:FREQuency:BANDwidth[:RESolution]:RATio.....................................................357
SPECtrum:FREQuency:FULLspan...................................................................................357
SPECtrum:FREQuency:MAGNitude:REFerence[:VALue]................................................... 357
SPECtrum:FREQuency:POSition.....................................................................................357
SPECtrum:FREQuency:SCALe....................................................................................... 358
SPECtrum:WAVeform:AVERage[:ENABle]........................................................................ 358
SPECtrum:WAVeform:MAXimum[:ENABle]....................................................................... 358
SPECtrum:WAVeform:MINimum[:ENABle]........................................................................ 358
SPECtrum:WAVeform:SPECtrum[:ENABle].......................................................................359
SPECtrum:FREQuency:RESet........................................................................................ 359
SPECtrum:MODE?
Queries the most recently activated spectrum analysis mode.
Return values:
<Mode> FFT | SPECtrum
*RST: FFT
Usage: Query only
SPECtrum:FREQuency:AVERage:COUNt <NoOfAvgs>
Defines the number of measurements to average for the average trace (see
SPECtrum:WAVeform:AVERage[:ENABle] on page 358).
Parameters:
<NoOfAvgs> Range: 2 to 1024
Increment: 2
*RST: 64
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO <State>
If enabled, the optimal resolution bandwidth is determined automatically by the spec-
trum application according to the frequency span and selected window type.
If disabled, the RBW is set according to the ratio defined by SPECtrum:FREQuency:
BANDwidth[:RESolution]:RATio on page 357.
Parameters:
<State> ON | OFF
*RST: ON
Spectrum Analysis