Rohde & Schwarz Scope Rider RTH1004 - Page 397

Remote Control Commands
R&S
®
Scope Rider RTH
397User Manual 1326.1578.02 ─ 12
Parameters:
<Range> <numeric value> | MIN | MAX | DEF
<numeric value>
The instrument has fixed measurement ranges: 1 A|10 A|100 A|
1000 A.
You can enter any value between the minimum and maximum
value. The instrument uses the next suitable range.
Range: 1 to 1000
*RST: 1
Default unit: A
Usage: Setting only
METer<m>:CONFigure:VOLTage:AC
METer<m>:CONFigure:VOLTage:DC
Sets the internal parameters and configures the range for voltage measurements.
Suffix:
<m>
.
1..4
Selects the voltmeter.
Parameters:
<Range> <numeric value> | MIN | MAX | DEF
<numeric value>
The instrument has fixed measurement ranges: 1 V|10 V|100 V|
1000 V.
You can enter any value between the minimum and maximum
value. The instrument uses the next suitable range.
Range: 1 to 1000
*RST: 1
Default unit: V
Usage: Setting only
15.8.2.3 METer<m>:SENSe:<function>:RANGe:UPPER Commands
METer<m>:SENSe:<function>:RANGe:UPPER commands set the measurement
range. You can use these commands in addition to METer<m>:CONFigure com-
mands if you want to change only the range.
METer<m>:SENSe:CURRent:AC:RANGe:UPPer.............................................................. 397
METer<m>:SENSe:CURRent:DC:RANGe:UPPer.............................................................. 397
METer<m>:SENSe:VOLTage:AC:RANGe:UPPer...............................................................398
METer<m>:SENSe:VOLTage:DC:RANGe:UPPer...............................................................398
METer<m>:SENSe:CURRent:AC:RANGe:UPPer <Range>
METer<m>:SENSe:CURRent:DC:RANGe:UPPer <Range>
Sets a fixed current range.
Voltmeter (R&S
RTH1004)