Waveform Setup
R&S
®
Scope Rider RTH
41User Manual 1326.1578.02 ─ 12
3.2.1 Vertical Settings
As long as the "Vertical" menu is open, the probe settings of active channels are
shown on top of the display.
Channel Index
Selects the channel to be configured. All settings in the channel menu belong to the
selected channel.
You can also shortly press the channel key to select a channel. If you press and hold
the channel key, the corresponding channel menu opens.
Channel <n>
Switches the selected channel on or off.
Remote command:
CHANnel<m>:STATe on page 299
Coupling
Selects the connection of the input signal. The current coupling of each channel is
shown in the channel label at the display bottom.
AC coupling. A high-pass filter removes the DC offset voltage from
the input signal if the DC component of a signal is of no interest. The
waveform is centered on zero volts.
DC coupling, the signal passes the input unchanged.
Remote command:
CHANnel<m>:COUPling on page 302
Vertical Setup
To Next Page
Loading...
