Rohde & Schwarz Scope Rider RTH1004 - Page 419

Remote Control Commands
R&S
®
Scope Rider RTH
419User Manual 1326.1578.02 ─ 12
Parameters:
<TrackScaling> ON | OFF
*RST: OFF
LOGGer:CURSor:COUPling <Coupling>
Couples the cursor lines so that the distance between the two lines remains the same
when one cursor is moved.
Parameters:
<Coupling> ON | OFF
*RST: OFF
LOGGer:CURSor:SCReen
Sets the cursors to a default position on the screen.
Usage:
Event
15.10.3.2 Cursor Results
LOGGer:CURSor<m>:RESult<n>[:AMPLitude]?................................................................419
LOGGer:CURSor:RESult<n>:DELTa?.............................................................................. 419
LOGGer:CURSor<m>:POSition.......................................................................................420
LOGGer:CURSor:TDELta?............................................................................................. 420
LOGGer:CURSor<m>:RESult<n>[:AMPLitude]?
Returns the measured value at the specified cursor line (y1 and y2 on the result dis-
play).
Suffix:
<m>
.
1..2
Specifies the cursor line.
<n> 1..4
Specifies the measurement. You can log the results of up to four
active measurements.
Return values:
<Yvalue> Measurement value
Usage: Query only
LOGGer:CURSor:RESult<n>:DELTa?
Returns the difference of the measured values at cursor line 1 and cursor line 2 (Δy on
the result display).
Data Logging