Rohde & Schwarz Scope Rider RTH1004 - Page 444

Remote Control Commands
R&S
®
Scope Rider RTH
444User Manual 1326.1578.02 ─ 12
Return values:
<StopTime> Range: -100E+24 to 100E+24
Increment: 100E-12
*RST: 0
Default unit: s
Usage: Query only
15.11.4 UART/RS-232/RS-422/RS-485 (Option R&S RTH-K2)
● UART Configuration..............................................................................................444
● UART Trigger........................................................................................................ 447
● UART Decode Results..........................................................................................448
15.11.4.1 UART Configuration
BUS:UART:SOURce.......................................................................................................444
BUS:UART:POLarity.......................................................................................................444
BUS:UART:TECHnology................................................................................................. 445
BUS:UART:THReshold................................................................................................... 445
BUS:SETReflevels......................................................................................................... 445
BUS:UART:STDBitrate....................................................................................................445
BUS:UART:BITRate........................................................................................................446
BUS:UART:SSIZe.......................................................................................................... 446
BUS:UART:PARity..........................................................................................................446
BUS:UART:SBIT............................................................................................................ 446
BUS:UART:ORDer......................................................................................................... 446
BUS:UART:FRAMemode................................................................................................ 447
BUS:UART:TOUT...........................................................................................................447
BUS:UART:SOURce <Channel>
Selects the input channel of the UART line.
Parameters:
<Channel> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C3 and C4: only R&S RTH1004
Digital channels are available if option R&S RTH-B1 is installed.
*RST: C1
BUS:UART:POLarity <Polarity>
Defines the logic states of the line. In idle high state, the idle state corresponds to a
logic 1, and the start bit to a logic 0. In idle low state, the idle state corresponds to a
logic 0, and the start bit to a logic 1. During idle time, no data is transmitted.
Parameters:
<Polarity> IDLLow | IDLHigh
*RST: IDLHigh
Protocol Analysis