Rohde & Schwarz Scope Rider RTH1004 - Page 450

Remote Control Commands
R&S
®
Scope Rider RTH
450User Manual 1326.1578.02 ─ 12
BUS:UART:WORD<m>:VALue?
Return the value of the specified symbol (word).
Suffix:
<m>
.
*
Selects the word.
Return values:
<Value> Decimal value
Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
15.11.5
CAN (Option R&S RTH-K3/R&S RTH-K9)
● CAN Configuration Settings.................................................................................. 450
● CAN Trigger.......................................................................................................... 454
● CAN Decode Results............................................................................................ 458
15.11.5.1 CAN Configuration Settings
BUS:CAN:DATA:SOURce............................................................................................... 450
BUS:CAN:TYPE............................................................................................................ 451
BUS:CAN:BITRate......................................................................................................... 451
BUS:CAN:TECHnology...................................................................................................451
BUS:CAN:DATA:THReshold............................................................................................452
BUS:SETReflevels......................................................................................................... 452
BUS:CAN:SAMPlepoint.................................................................................................. 452
BUS:CAN:FDATa:ABITrate..............................................................................................452
BUS:CAN:FDATa:ASAMplepoint......................................................................................452
BUS:CAN:FDATa:DBITrate..............................................................................................453
BUS:CAN:FDATa:DSAMplepoint......................................................................................453
BUS:CAN:FDATa:ENABle............................................................................................... 453
BUS:CAN:FDATa:PSTandard.......................................................................................... 453
BUS:CAN:DATA:SOURce <Channel>
Sets the input channel of the CAN line.
Parameters:
<Channel> C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C3 and C4: only R&S RTH1004
Digital channels are available if option R&S RTH-B1 is installed.
*RST: C1
Usage: Asynchronous command
Protocol Analysis