Remote Control Commands
R&S
®
Scope Rider RTH
453User Manual 1326.1578.02 ─ 12
Parameters:
<ArbSamplePoint> Range: 10 to 95
Increment: 1
*RST: 66
Default unit: %
BUS:CAN:FDATa:DBITrate <DataCustomBitrate>
Sets the bit rate of the data phase. The data rate can be higher than the arbitration
rate, but it is uniform and fixed for a given CAN FD bus.
The setting is available in CAN FD option R&S RTH-K9.
Parameters:
<DataCustomBitrate> Range: 10000 to 15000000
Increment: 1
*RST: 50000
Default unit: bps
BUS:CAN:FDATa:DSAMplepoint <DataSamplePoint>
The sample point divides the data phase into two distinct time segments. The length of
the time segments is defined in time quanta according to network and node conditions
during CAN FD development.
The setting is available in CAN FD option R&S RTH-K9.
Parameters:
<DataSamplePoint> Range: 10 to 95
Increment: 1
*RST: 66
Default unit: %
BUS:CAN:FDATa:ENABle <State>
Enables the CAN FD protocol configuration. It BUS:CAN:FDATa:ENABle state is OFF,
then the CAN protocol is selected.
The setting is available in CAN FD option R&S RTH-K9.
Parameters:
<State> ON | OFF
BUS:CAN:FDATa:PSTandard <ProtocolStandard>
Only available for CAN FD buses. Selects if the tested signal is an ISO CAN FD signal
or not.
Parameters:
<ProtocolStandard> ISO | NISO
Protocol Analysis
To Next Page
Loading...
