Rohde & Schwarz Scope Rider RTH1004 - Page 470

Remote Control Commands
R&S
®
Scope Rider RTH
470User Manual 1326.1578.02 ─ 12
BUS:LIN:FCOunt?..........................................................................................................470
BUS:LIN:FRAMe<m>:BYTE<n>:STATe?.......................................................................... 470
BUS:LIN:FRAMe<m>:BYTE<n>:VALue?.......................................................................... 470
BUS:LIN:FRAMe<m>:CSSTate?......................................................................................471
BUS:LIN:FRAMe<m>:CSValue?...................................................................................... 471
BUS:LIN:FRAMe<m>:DATA?.......................................................................................... 471
BUS:LIN:FRAMe<m>:IDPValue?..................................................................................... 472
BUS:LIN:FRAMe<m>:IDSTate?....................................................................................... 472
BUS:LIN:FRAMe<m>:IDValue?....................................................................................... 472
BUS:LIN:FRAMe<m>:STARt?......................................................................................... 473
BUS:LIN:FRAMe<m>:STOP?..........................................................................................473
BUS:LIN:FRAMe<m>:STATus?....................................................................................... 473
BUS:LIN:FRAMe<m>:SYMBol?.......................................................................................473
BUS:LIN:FRAMe<m>:SYSTate?...................................................................................... 474
BUS:LIN:FCOunt?
Returns the number of decoded frames in the acquisition.
Return values:
<Count> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS:LIN:FRAMe<m>:BYTE<n>:STATe?
Returns the state of the specified byte.
Suffix:
<m>
.
*
<n> *
Return values:
<ByteState> OK | STERror | SPERror | UVAL | NOEXists | INSufficient
STERror: start error
SPERror: stop error
UVAL: unexpected value
NOEXists: byte does not exist
INSufficient: the frame is not completely contained in the acqui-
sition. The decoded part of the frame is valid.
*RST: OK
Usage: Query only
BUS:LIN:FRAMe<m>:BYTE<n>:VALue?
Returns the value of the specified byte.
Protocol Analysis