Rohde & Schwarz Scope Rider RTH1004 - Page 60

Waveform Setup
R&S
®
Scope Rider RTH
60User Manual 1326.1578.02 ─ 12
Pulse Type
Sets the type of the sync pulse, either bi-level sync pulse (used in SDTV signals), or tri-
level sync pulse (used in HDTV signals).
Figure 3-10: Bi-level (left) and tri-level (right) sync pulses
This setting is available for user-defined video signals if "Standard" is set to "Custom".
Remote command:
TRIGger:TV:CUSTom:STYPe on page 317
Line Period
Sets the duration of a single video line, the time between two successive sync pulses.
Line period
This setting is available for user-defined video signals if "Standard" is set to "Custom".
Remote command:
TRIGger:TV:CUSTom:LDURation on page 317
Pulse Width
Sets the width of the sync pulse.
Trigger