Rohde & Schwarz Scope Rider RTH1004 - Page 72

Waveform Setup
R&S
®
Scope Rider RTH
72User Manual 1326.1578.02 ─ 12
Description of settings
Figure 3-18: Serial pattern trigger
Clock Source.................................................................................................................72
Clock Slope................................................................................................................... 72
Data Source.................................................................................................................. 72
Set Serial Pattern.......................................................................................................... 72
Bit Order........................................................................................................................73
Clock Source
Selects the input channel of the clock signal.
Remote command:
TRIGger:SPATtern:CSOurce[:VALue] on page 328
Clock Slope
Sets the edge at which the data value is sampled.
●
rising edge
●
falling edge
●
rising and falling edges are considered (double data rate).
At double data rate, "First Clock Edge of Pattern" defines the edge at which the first
bit of the pattern is sampled: at the rising clock edge, falling clock edge, or the first
edge that is detected ("Either").
Remote command:
TRIGger:SPATtern:CSOurce:EDGE on page 328
TRIGger:SPATtern:CSOurce:FIRStedge on page 329
Data Source
Selects the input channel of the data signal.
Remote command:
TRIGger:SPATtern:DSOurce[:VALue] on page 328
Set Serial Pattern
The pattern defines the bits of the serial data to be found in the data stream.
Trigger