Signal Generator Settings
R&S
®
SGS100A
126User Manual 1173.9105.02 ─ 12
Connected
The connection state indicator visualizes the state of selected extension:
●
Grey - the connection to the extension is not activated ("Extension > Available
Instruments > Instrument# > Select > Off")
●
Green - the extension is connected to the master instrument and can be manually
and remotely operated
●
Red - the extension is in standby or locked state, or is performing a time consum-
ing operation
Available Instruments
Lists all available instruments that may serve as an extension to the R&S SGS.
Each instrument is represented by:
"Symbolic Name"
Alias name of the instrument as it is defined in the main panel of
R&S SGMA-GUI.
"Channel"
Hardware channel, "Socket", "LAN", "USB" or "PCIe", used by the
extension as remote control channel
"Select"
State of the remote connection to the extension.
The R&S SGMA-GUI indicates an activated extension mode as fol-
lows:
Remote command:
:EXTension:BUSY[:STATe]? on page 211
:EXTension:INSTruments:NAME? on page 210
:EXTension:INSTruments:REMote:CHANnel? on page 210
:EXTension:INSTruments:REMote:LAN:NAME? on page 211
:EXTension:INSTruments:REMote:SERial? on page 211
:EXTension:INSTruments:SCAN[:STATe] on page 210
:EXTension:REMote:STATe? on page 210
Scan
Triggers a scan function and searches for instruments connected to the instrument via
all the available interfaces.
Remote command:
:EXTension:INSTruments:SCAN[:STATe] on page 210
Test Signal Connections
The "Test" function triggers a test of all signal connections between the instrument and
the extension. The schematic diagram displays the required physical signal connection
for the current test setup and the connection state.
A faulty connection is marked with a red line crossing the drawn blue connection line
as shown in Figure 7-9. If your connection is marked as faulty check whether the
cables are connected properly and if the connection cables are functioning properly.
Extension
To Next Page
Loading...
