General Instrument Settings and Instrument Setup
R&S
®
SGS100A
134User Manual 1173.9105.02 ─ 12
Only if the instrument is equipped with an older firmware version, a firmware update
before enabling the software option may be required. The information on the valid firm-
ware versions for the purchased software option is provided together with the option.
See:
●
Chapter 9.12, "How to Install a New Firmware Version on the Instrument",
on page 159 for information on how to perform firmware update
●
Chapter 9.13, "How to Activate Options", on page 161 for instruction on how to
install new options
The firmware update is also described in the service manual.
8.5 NRP Info
► To access this dialog, select "SGMA-GUI > Instrument Name > Setup > NRP Info"
Current Sensors
Shows the sensors that are connected to the generator with information on serial num-
ber, the revision state, and some characteristic features.
8.6 Protection
The "Protection" dialog provides access to the unlocking of protected service functions
(authorized personnel of R&S Service Departments only).
Unlocking of protected service functions
1. Select "SGMA-GUI main panel > Instrument Name > Setup > Protection".
The "Protection" dialog provides access to the unlocking of protected service func-
tions (authorized personnel of R&S Service Departments only).
Protection
To Next Page
Loading...