Rohde & Schwarz SGS100A - Factory Preset; Remote Channels

General Instrument Settings and Instrument Setup
R&S
®
SGS100A
142User Manual 1173.9105.02 ─ 12
8.10 Remote Channels
The "Remote" dialog provides access to the settings for remote control.
► To access this dialog, select "SGMA-GUI > Instrument Name > Setup > Remote".
Visa Resource Strings
Indicates the VISA resource strings used for remote control of the instrument. A sepa-
rate string is provided for remote control via the different interfaces.
Note: For background information and description of the syntax of the VISA resource
strings, refer to the description of the corresponding interface in Chapter 10.1, "Remote
Control Interfaces and Protocols", on page 162.
Remote command:
:SYSTem:COMMunicate:HISLip:RESource? on page 272
:SYSTem:COMMunicate:NETWork:RESource? on page 271
:SYSTem:COMMunicate:SOCKet:RESource? on page 273
:SYSTem:COMMunicate:USB:RESource? on page 273
:SYSTem:COMMunicate:PCIexpress:RESource? on page 272
Device Identity
Triggers the device identification function. The [LAN] LED on the front panel of the
selected instrument blinks.
See also Chapter 6.4.4, "Bidirectional Instrument Identification ", on page 71.
8.11 Factory Preset
The "Factory Preset" dialog provides a function to reset the instrument's settings to
their factory states
Factory Preset