Rohde & Schwarz SGS100A - How to Switch between the Operating States

Performing Configuration Tasks
R&S
®
SGS100A
156User Manual 1173.9105.02 ─ 12
9.9 How to Switch between the Operating States
The Figure 9-4 gives an overview of the operating states of the instruments and how to
trigger the switch-over between them.
Figure 9-4: Operating states
:RESTart, :STANdby = SCPI commands
"Setup > Standby", "Setup > Restart", "Shut Down Instru-
ments and Exit"
= R&S SGMA-GUI controls
POWER ON/STANDBY, POWER SWITCH ON/OFF = Hardkey controls on the front/rear panel of the
instrument
The Table 9-2 provides a short description of the operating states and their indication.
Table 9-2: Indication of the operating states
Operating
state
Description Indication
Off The instrument is shut down. All LEDs on the front panel of the instrument
are off.
Booting The instrument boots the operating system
and starts the instrument firmware.
If the previous session was terminated reg-
ularly, the instrument uses the last setup
with the relevant instrument settings.
The green [POWER ON /STAND BY] key
blinks.
How to Switch between the Operating States