Network and Remote Control Operation
R&S
®
SGS100A
189User Manual 1173.9105.02 ─ 12
Connecting and configuring the monitoring PCs
In the "Setup > Security > Security Settings" dialog, check the state of the LAN and
USB interfaces and enable them if necessary.
1. Connect the monitoring PC to the instrument.
Note: Choose the hardware interface considering the limitations described in
Table 10-2.
2. Configure the instrument in the R&S SGMA-GUI, see Chapter 6.4.2, "Handling
Instruments in the R&S SGMA-GUI", on page 68.
3. In the "SGMA-GUI > Setup > Instruments > Edit Instruments" dialog, disable
"Exclusive Access".
Note: The two functions "Exclusive Access" and monitoring are mutually exclusive.
4. Send remote control commands from the controller to the instrument.
5. Open the corresponding dialogs in the R&S SGMA-GUI. Observe the status of the
parameters.
Using the R&S SGMA-GUI to Monitor the Remote Control Operation
To Next Page
Loading...
