Remote Control Commands
R&S
®
SGS100A
223User Manual 1173.9105.02 ─ 12
APASsive
The attenuator is switched automatically. The level settings are
made only for the passive reference circuits. The high-level
ranges are not available.
FIXed
The level settings are made without switching the attenuator.
When this operating mode is switched on, the attenuator is fixed
to its current position and the resulting variation range is defined.
*RST: AUTO
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "Mode" on page 90
:OUTPut[:STATe]:PON <Pon>
Selects the state which the RF output assumes when the instrument is switched on.
Parameters:
<Pon> OFF | UNCHanged
*RST: UNCHanged
Example: See Chapter 11.1.4, "Advanced Task for Optimizing Perform-
ance", on page 196.
Manual operation: See "Power-On State" on page 92
:OUTPut[:STATe] <State>
Activates/ deactivates the RF output.
Parameters:
<State> 0 | 1 | OFF | ON
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "RF On/Off" on page 66
11.12 SENSe, READ, INITiate and SLISt Subsystems
These subsystems contain the commands for configuring the power measurements
with R&S NRP power sensor connected to the R&S SGS.
SENSe, READ, INITiate and SLISt Subsystems
To Next Page
Loading...
