Rohde & Schwarz SGS100A - Page 249

Remote Control Commands
R&S
®
SGS100A
247User Manual 1173.9105.02 ─ 12
Parameters:
<Q> float
Range: -5 to 5
Increment: 0.01
*RST: 0
Default unit: PCT
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "Offset" on page 122
[:SOURce]:IQ:IMPairment:QUADrature[:ANGLe] <Angle>
Sets the quadrature offset for the digital I/Q signal.
Parameters:
<Angle> float
Range: -8 to 8
Increment: 0.01
*RST: 0
Default unit: DEG
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "Quadrature Offset" on page 123
[:SOURce]:IQ:IMPairment[:STATe] <State>
Activates/ deactivates the three impairment or correction values LEAKage, QUADra-
ture and IQRatio for the baseband signal prior to input into the I/Q modulator.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 0
Example: See Chapter 11.1.2, "Generating an I/Q Modulated Signal",
on page 193.
Manual operation: See "State" on page 122
[:SOURce]:IQ:CREStfactor <CrestFactor>
Sets the crest factor of the IQ modulation signal.
Parameters:
<CrestFactor> float
Range: 0 to 80
Increment: 0.01
*RST: 0
Default unit: dB
SOURce:IQ Subsystem