Rohde & Schwarz SGS100A - System:emode; System:error:all

Remote Control Commands
R&S
®
SGS100A
266User Manual 1173.9105.02 ─ 12
:SYSTem:COMMunicate:SERial:RESource?.....................................................................272
:SYSTem:COMMunicate:SERial:SBITs............................................................................. 272
:SYSTem:COMMunicate:HISLip:RESource?..................................................................... 272
:SYSTem:COMMunicate:PCIexpress:RESource?.............................................................. 272
:SYSTem:COMMunicate:SOCKet:PORT...........................................................................273
:SYSTem:COMMunicate:SOCKet:RESource?...................................................................273
:SYSTem:COMMunicate:USB:RESource?........................................................................ 273
:SYSTem:REBoot...........................................................................................................273
:SYSTem:RESTart..........................................................................................................274
:SYSTem:SHUTdown..................................................................................................... 274
:SYSTem:STARtup:COMPlete?....................................................................................... 274
:SYSTem:PROTect<ch>[:STATe]......................................................................................274
:SYSTem:HARDware:ASSembly<dir>:NAME?.................................................................. 275
:SYSTem:HARDware:ASSembly<dir>:PNUMber?............................................................. 275
:SYSTem:HARDware:ASSembly<dir>:REVision?.............................................................. 275
:SYSTem:HARDware:ASSembly<dir>:SNUMber?............................................................. 276
:SYSTem:SOFTware:OPTion<dir>:DESignation?...............................................................276
:SYSTem:SOFTware:OPTion<dir>:EXPiration?................................................................. 276
:SYSTem:SOFTware:OPTion<dir>:LICenses?...................................................................277
:SYSTem:SOFTware:OPTion<dir>:NAME?....................................................................... 277
:SYSTem:MMEMory:PATH:USER?.................................................................................. 277
:SYSTem:OSYStem?......................................................................................................277
:SYSTem:EMODe <Mode>
Enables and selects the Eco Mode. With enabled eco mode EM1 the doubler stage in a
12 GHz instrument is permanently switched off to reduce power consumption and the
maximum frequency is limited to 6 GHz.
Parameters:
<Mode> OFF | EM1
*RST: OFF
Example: see Chapter 11.1.1, "Performing General Task for Instrument
Setup", on page 191
:SYSTem:ERRor:ALL?
Queries the error/event queue for all unread items and removes them from the queue.
Return values:
<All> string
Error/event_number,"Error/event_description>[;Device-depend-
ent info]"
A comma separated list of error number and a short description
of the error in FIFO order.
If the queue is empty, the response is 0,"No error"
Positive error numbers are instrument-dependent. Negative
error numbers are reserved by the SCPI standard.
SYSTem Subsystem