Rohde & Schwarz SGS100A - System:communicate:network:resource; System:communicate:network[:Ipaddress]:Subnet:mask; System:communicate:serial:baud; System:communicate:serial:parity

Remote Control Commands
R&S
®
SGS100A
271User Manual 1173.9105.02 ─ 12
Parameters:
<Gateway> string
Range: 0.0.0.0 to ff.ff.ff.ff
Example:
SYSTem:COMMunicate:NETWork:IPADdress:GATeway
'1.2.3.4'
sets the IP address of the default gateway.
Manual operation: See "Default Gateway" on page 141
:SYSTem:COMMunicate:NETWork[:IPADdress]:SUBNet:MASK
<Mask>
Sets the subnet mask.
Parameters:
<Mask> string
Example:
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:
MASK '255.255.0.0'
determines the subnet mask.
Manual operation: See "Subnet Mask" on page 141
:SYSTem:COMMunicate:NETWork:RESource?
Queries the VISA resource string, used for remote control of the instrument with VXI-11
protocol.
Return values:
<Resource> string
Example:
SYSTem:COMMunicate:NETWork:RESource?
Response: "TCPIP::192.1.2.3::INSTR"
Usage: Query only
Manual operation: See "Visa Resource Strings" on page 142
:SYSTem:COMMunicate:SERial:BAUD <Baud>
Sets the baudrate for the serial remote control interface.
Parameters:
<Baud> 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200
*RST: n.a. (factory preset: 115200)
Example:
SYSTem:COMMunicate:SERial:BAUD 115200
Sets 115200 baudrate.
:SYSTem:COMMunicate:SERial:PARity <Parity>
Sets the parity for the serial remote control interface.
SYSTem Subsystem